TRAILER MOVERS

ENDURO

  • Simple to use Remote Control Enduro Trailer Mover, directs the caravan into any position required. Works on most surfaces in most conditions. Control when going up or downhill, control when hitching, control when unhitching.
“The e-go exceeds my expectations. It did very well on my inclined driveway with some gravel moving effortlessly and there was no slippage back when stopped. My adult daughter quickly learned to expertly maneuver and said it was great fun. I no longer fear getting stuck somewhere because of the trailer and enjoy traveling much more.”
Robert Shulman
Trailer Mover Owner

ENDURO

HEAVY DUTY CROSS ACTUATION

  • Corrosive resistant, electroplated and powder coated for enhanced durability.
  • Cross actuation allows both rollers to be engaged simultaneously from one side
  • Works with single and twin axle travel trailers
USER MANUAL

FAQs

Will the Enduro fit my trailer?

  • Yes, the enduro will fit any trailer. The kit comes complete with a set of chassis adapter plates that must be attached to the chassis and the enduro then clamps onto this plate. The chassis plates are designed to fit any box section chassis (see photo below), come with bolts and nuts, and will enable the mover to fit precisely, avoiding leaf spring suspension arms, chassis cross members, and any other obstructions. The ground clearance from the bottom of the chassis must be a minimum of 165mm – the Enduro will decrease by 50mm.

Will the Enduro fit on twin axle trailers?

  • Yes, the enduro will fit all single axle and most twin axle trailers. Refer to the fitting instructions in the product manual and if still unsure contact us.

Can I fit the Enduro myself?

  • Please review the User Manual which may help you to decide if self-fit is an option, or contact us for further advice. Alternatively, please contact your dealer or a mobile fitter.

Does the Enduro have a soft start and stop?

  • It has precision control operation and provides excellent accuracy.

Is the enduro suitable for tough road conditions?

  • Yes, the enduro is tough and durable, ideally suited to the demands of outback roads.

Where is the best location for the mover?

  • The best location for the Enduro is in front of the axle. However, if this is not possible it is usually possible to fit behind the axle. Please contact us or your dealer for advice.

Does it fit on a trailer with shock absorbers?

  • Yes.

Where do I find the serial numbers?

  • The serial numbers are located on the ends of the motor assemblies; there are two serial numbers, one on each motor, and both numbers must be provided when completing your product registration.

How much clearance back from the tires do I need?

  • You will need 16” of clearance back from the tire to have enough room to install the Trailer Mover. Steps can be repositioned and wastewater outlets can be moved or extended as required.

Where is the best location for the mover?

  • The best location for the Enduro is in front of the axle. However, if this is not possible it is usually possible to fit behind the axle. Please contact us or your dealer for advice.

Trailer Movers